Files
solidcraft/tests
jyvikoandClaude Opus 5.5 191fa98395 Fillet rig: the R7 round past a thin wall's inside corner held to its exact volume
fillets/1668-fillet-outer-top-edge-of-thin-wall-r7-past-inside-corner (and the
both-sides R7 case) now grade the volume at rel 1e-6 (0.04 mm^3), not the rig's
1e-3. The closed form is exact: V0 = 104 64 42 - 100 60 40 less the round's
section (1-pi/4) 49 along 104 plus its part over the hollow, the square
[25,30] x [35,40] outside the circle about (25,35), Int_sqrt24^5 (5 - sqrt(49-u^2)) du
= 0.0050679 mm^2 (a 0.0005 grid gives the same to 1e-9), along 100: 38458.896.
SMLib gives 38458.389, 0.507 mm^3 less: exactly that part over the hollow, which is
not material, taken anyway where the round opens its slit. The unit test's bound
was right; the case goes on KNOWN_FAILING with that cause. The both-sides case
passes at the tighter tolerance.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-30 07:37:21 -04:00
..