Files
solidcraft/crates/engine
semmelrindeandClaude Opus 5.5 18dc05c83d Sketch Trim and Extend: a crossing at a curve's own end is that end, leaving no curve of no length (#9012)
* Sketch Trim: a cut at a curve's own end leaves no piece of no length

A curve that ends where another one ends crosses it there only within the
intersection's tolerance (1e-6), but bracket dropped cuts at the curve's
ends only within 1e-9 of its parameter range. A line ending on an arc's end,
trimmed from its other end, was cut a hair inside its own end and kept a
piece about 1e-7 mm long (found by a local trim fuzzer: 78 such trims in
4000 sketches, and 8 breaks). bracket now also drops a cut within that
tolerance of the curve's ends, as add_cut merges cuts that close together.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Extend: a touch at an arc's growing end is that end, not a stop

An arc whose end is where a line ends that touches the arc's circle there
found the touch a hair beyond the end (within the intersection's tolerance),
stopped on it, and added an arc from that point to itself. A hit within that
tolerance of the growing end (1e-6, as for the far end) is now the end.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-29 20:48:18 +00:00
..