* Sketch: a construction line with a length can be a normal line (#10258)
`construction: false` on a construction line command that has a
`length` makes the segment a normal sketch line, ready to close a
profile, instead of construction geometry. The default stays
construction, and an infinite line is always construction.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
* Sketch: a length box in the construction line tools (#10258)
The horizontal, vertical, parallel and perpendicular construction line
tools show a Length box beside the pointer from the start. It stays
empty (shown as infinite) and leaves the keyboard to the tool's
shortcuts until a digit is typed; then the box takes the keyboard.
Without a length the tools work as before: one click, an infinite line.
With a length the first click sets the start and a second click the side
the segment runs to, sent as the command's `length` and `near`, so the
segment gets its length dimension. The angle tool has a Length box
beside its Angle box. A typed length keeps the start's snap, and the
preview draws the segment the click will create.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
* Sketch: a construction/normal switch in the construction line tools (#10258)
A Construction | Normal switch sits under the Length box of the
construction line tools. Normal sends `construction: false`, so a
segment with a length becomes a normal sketch line, ready to close a
profile, without converting it afterwards. The switch starts at
Construction with each start of a tool. An infinite line is always
construction, so without a length the switch is greyed out and its
tooltip says why. It belongs to the tool alone: the Sketch Palette's
drawing line type (X) is left as it is.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
---------
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>