Files
solidcraft/crates/engine
0c094142d3 Sketch Break and Extend: a cut or stop on a shape's centre ends there, with no second point (#12299) (#12301)
* Sketch Break and Extend: tests for a cut or stop on a center rectangle's centre

Breaking a center rectangle's diagonal at the centre leaves two points there, and extending a line up to the centre ends it on one diagonal only. These tests fail on main.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Break and Extend: a cut or stop on a held midpoint ends there, as Trim does

Break dropped the broken line's Midpoint and joined the pieces at a new point held only on the cutter, so a center rectangle's centre came loose and a corner drag pulled the two points apart. It now uses Trim's rule (one helper, hold_cut): the pieces meet at the held point, which moves its hold to the cutter's middle when the sketch already implies that, and otherwise stays on the cutter.

Extend stopped on a point it lays on the curve it meets unless that curve ends there. A point held at another line's middle (a center rectangle's centre) is now a stop too, so the extension joins it.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
Co-authored-by: bherbruck <brennen.herbruck@gmail.com>
2026-11-05 23:27:01 +00:00
..