Files
solidcraft/crates/doc
6d410c342c Joints: origins on an edge of a face, at its middle or a corner (#2403) (#2404)
* Joints: a face or circle origin keeps its turn as the face tilts

A face- or circle-centre joint origin worked out its frame's x from the normal alone
(`Vec3::any_perp`), which switches axis where the normal crosses 0.9 along X: a part on a face
tilted past about 64° by a parameter spun a right angle about the face. New origins keep the x
they have when picked (`x`, component coordinates) and each solve lays it onto the face as it is
now, so the part tilts with the face without spinning. Origins saved without it are placed as
before.

Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>

* Joints: origins on an edge of a face, at its middle or a corner

`joint.origin` and `joint.create` take `edge: [x,y,z]` (a point on an edge of a planar face),
with `on` (which face; default the larger planar face beside it) and `corner` (the end near that
point). The origin sits at the edge's middle (z out of the face, y into it) or at the corner (x
and y along its two edges into the face, right-handed whichever way the edges run). The edge, the
face and the corner's other edge are kept by name and found again on every solve, so a part set
40 mm in from a panel's corner stays there when the panel changes size; a name that finds nothing
leaves the joint out with the reason.

Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 (1M context) <noreply@anthropic.com>
Co-authored-by: bherbruck <brennen.herbruck@gmail.com>
2026-10-18 18:10:28 -04:00
..