Files
solidcraft/crates/engine
bherbruckandClaude Opus 5.5 971b223246 Thread: turn a shaft thicker than a modelled thread down to its major diameter (#4256)
* Thread: turn a shaft thicker than a modelled thread down to its major diameter

A modelled external thread on a shaft thicker than the thread no longer refuses: the shaft
is turned down to the major diameter over the threaded length (run past a free end of the
face), then the thread is cut as before. The turned face is named F<n>:turned and the step
it leaves F<n>:shoulder:start/end. A shaft the part goes on around is refused rather than
cut into, shafts under the minor diameter and cosmetic threads on thicker shafts are still
refused.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Thread preview test: an 8 mm shaft is turned down for M6; M10 still refused

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-21 08:27:18 -04:00
..