A 240 deg window through a cylinder's wall and a saddle window in a torus's inner
wall, their cut faces deleted, patched G0 and G1 and stitched, become surfaces rig
cases: the G1 cylinder seals to the whole cylinder's volume within 0.5 % with G1
seams on the window's edges, the G1 torus reaches G1 on its rim, the G0 fills are
one valid solid. They fail today as the unit tests did (the general fill refuses:
it folds) and are on KNOWN_FAILING; the unit tests are removed.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
A face of degree 1 in one direction (an extruded spline) was refused with "a fairness term does
not fit the net's degrees": the thin-plate energy's S_vv asks for second derivatives a linear
direction does not have. On every span that term is exactly zero, so it is dropped; the energy is
the bending along the curve and the twist. A face whose held layers are its whole net (a
single-span cubic with its edges kept, an extruded curve's two rows) has no interior control
point: it is left exactly as it is, its energy reported unchanged, 0 steps.
cov-fair-single-span-face-has-nothing-free-to-move passes and leaves KNOWN_FAILING.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- #58: a fillet's tangent-point step no longer depends on the blends before it (solidcore #1173).
- #59: the fillet clean-up keeps the target's edges and faces by a mark, not by address (#1176).
- #60: capi test, a line projected through a sphere's poles meets itself smoothly at each pole.
- #61: offset faces removes a step wall the move closes to nothing and merges the two tops, so
shell/cov-replace-face-step-onto-the-higher-face builds.
- #62: thicken puts a flat side wall on its plane (solidcore #1599), so a cylinder sheet's end
rings are planes: surfaces/cov-thicken-cylinder-sheet-symmetric-tube passes.
Both cases leave KNOWN_FAILING.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The shared core (crates/smlib, the grader, doc eval.rs, engine features.rs and the kernel's core)
is in PATHS-ALL; the new areas' copies of it are dropped, so an area reruns on its own files and the
core reruns them all. sheet-metal also watches the sheet commands, the sheet document and the DXF
writer. 116 commands a case now uses leave EXEMPT; 25 geometry commands are still to cover.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>