diff --git a/tests/kernel-cases/fillets/KNOWN_FAILING b/tests/kernel-cases/fillets/KNOWN_FAILING index b20f9d06a..1b1431351 100644 --- a/tests/kernel-cases/fillets/KNOWN_FAILING +++ b/tests/kernel-cases/fillets/KNOWN_FAILING @@ -9,6 +9,8 @@ 2893-chamfer-two-distances-elliptical-rim SMLib status 1001: the two arcs of the rim take their chamfer offsets each at its own midpoint, where the faces' angle differs (78.5 and 101.5 deg), and their chamfers do not meet at the tangent corners (held for the owner's ruling on unequal chamfers of a varying angle) 4782-fillet-bar-edge-wider-than-both-faces SMLib status 1001: a convex round past both its faces is not yet built by subtraction 5158-fillet-round-just-past-a-10mm-face SMLib status 1001: the round passes 5e-6 under the box's top back edge, inside the body's tolerance (1e-5), and subtracting its removal region maps that edge to two of the region's faces (SmTopologyIntersector); 10.0001-10.04 open +851-fillet-arc-then-top-front SMLib status 1001: the top front edge's tangent chain (the edge, the arc round's end curve on the front face, the upright under it) rounded R2; along the end curve the R2 ball sits on the arc round's own centre circle, so that piece is the ball about (39.2538, -19, 8) touching front, top and wall (a torus of tube-centre radius 0), the three-edge rolling-ball corner; the same piece on a plane end arc builds (851-fillet-top-front-then-front-left-upright) +851-fillet-top-front-then-upright SMLib status 1001: the upright's tangent chain (the upright, the first round's end curve on the wall, the arc's top edge) rounded R2; along the end curve the R2 ball sits on the first round's axis, so that piece is the ball about (39.2538, -19, 8) touching front, top and wall (a torus of tube-centre radius 0), the three-edge rolling-ball corner; the upright alone builds, the upright with the end curve fails the same; the same piece on a plane end arc builds (851-fillet-top-front-then-front-left-upright) 9-fillet-corner-curvature-with-reduce-fit not supported yet: solid.fillet builds corner g2 with the exact fit only 9-fillet-corner-curvature-with-taper-fit not supported yet: solid.fillet builds corner g2 with the exact fit only cov-fillet-g2-corner-beside-a-cylinder not supported yet: the curvature fillet builds its sections only between planar faces ("a picked edge is not on the face beside it" on the cylinder's arc)