diff --git a/tests/kernel-cases/fillets/KNOWN_FAILING b/tests/kernel-cases/fillets/KNOWN_FAILING index e87e0fcef..a319fc13f 100644 --- a/tests/kernel-cases/fillets/KNOWN_FAILING +++ b/tests/kernel-cases/fillets/KNOWN_FAILING @@ -15,8 +15,6 @@ 1080-fillet-sloped-basin-1-mm-rim-r4-4-edges not supported yet: a convex round past its face is not yet built by subtraction 1113-chamfer-arc-top-edge-full-wall-height-refused builds the chamfer as tall as the wall where it should be refused as too large 1207-fillet-bar-top-edge-after-boss-arc-round-r0-5 SMLib's check refuses the round: internal coincident control points in a B-spline curve (an internal pole) -1207-fillet-concave-arc-bar-top-into-cylinder-solver-residues SMLib status 1001: SmFilletNx1Corner cannot make the topology at the arc's end (fillet error 3, corner type 8) -1207-fillet-corner-after-round-running-into-cylinder-solver-residues SMLib's check refuses the round: its corner's surface of revolution is close to singular at its boundary (SmSurface test 5) 1668-fillet-outer-top-edge-of-thin-wall-r7-past-inside-corner a slit along the hollow, 0.507 mm^3 off: 38458.389 is V0 less the round's whole section along 104, so the section's part over the hollow (0.005068 mm^2 along 100), which is not material, is taken anyway 190-fillet-disc-rim-past-its-2mm-wall SMLib status 1001: a convex round past its face is not yet built by subtraction 2852-fillet-outer-round-r30-past-inner-round-refused refused for another reason: SMLib's result is not a closed solid, not too large naming 25.24 @@ -34,7 +32,6 @@ 851-chamfer-knife-edge-tip-2-box-less-cylinder SMLib SM_ERR_INVALID_INPUT on the knife edge (opposite normals on its two faces) 851-chamfer-knife-edge-tip-2-sketched SMLib SM_ERR_INVALID_INPUT on the knife edge (opposite normals on its two faces) 851-chamfer-knife-edge-tip-5 SMLib SM_ERR_INVALID_INPUT on the knife edge (opposite normals on its two faces) -896-fillet-edge-tangent-at-one-end-into-cylinder SMLib's check refuses the round that fades out at the edge's tangent end: internal poles, coincident control points, cusps 9-fillet-corner-curvature-with-reduce-fit not supported yet: solid.fillet builds corner g2 with the exact fit only 9-fillet-corner-curvature-with-taper-fit not supported yet: solid.fillet builds corner g2 with the exact fit only 926-chamfer-top-edge-ending-on-boss-wall-above-it not supported yet: the chamfer is refused as larger than its faces where it ends on the boss's wall