Joints: a replaced motion link keeps the driven joint where it is; links count in dof (#2898)
Thanks @SS-EN.
This commit is contained in:
1 parent
4d99d79205
commit
98c30d28f9
4 files changed
+246
-20
No files matched your search
@@ -108,7 +108,9 @@ ratio comes from the parts rather than a typed number:
|
||||
A radius or pitch may be an expression of the design's parameters, and a picked face is found
|
||||
again whenever the design changes. Change the parameter or the gear's diameter, and the ratio
|
||||
follows. The new link leaves the driven joint where it is, so teeth modelled in mesh stay in mesh.
|
||||
**Reverse** turns the driven joint the other way, for joints whose axes point opposite ways. These
|
||||
**Reverse** turns the driven joint the other way, for joints whose axes point opposite ways.
|
||||
Redefining a link (`link: i`, such as turning it the other way with **Reverse**) also leaves the
|
||||
driven joint where it is, so the gears stay in mesh at the pose they are in. These
|
||||
couplings are motion links, so they work in closed loops, with contact sets and in motion studies:
|
||||
a rack can push the piston of a slider-crank, or a pinion can steer through a rack and its tie
|
||||
rods. Drive the joint that drives the coupling (joint 1, the pinion, or the screw's turn), not the
|
||||
@@ -158,7 +160,8 @@ example driving a rocker beyond its swing, the motion stops at the last position
|
||||
closes, and the drive reports `stopped_by_loop`. A loop that cannot close at all is listed
|
||||
under `conflicts` and nothing in it moves. `joint.list` reports how many degrees of freedom each
|
||||
part still has with its loops closed: the moving parts of a four-bar have one between them, and a
|
||||
loop locked by a rigid joint has none. The Drive Joints dialog says when a drive stops short and
|
||||
loop locked by a rigid joint has none. A joint a motion link drives adds no freedom of its own:
|
||||
two meshed gears on a fixed housing have one between them, each turning with the driving gear. The Drive Joints dialog says when a drive stops short and
|
||||
why. While it previews, a row under the values gives the value the joint reached and the reason
|
||||
(the loop that can't close further, or the two parts a contact set keeps apart), and after OK the
|
||||
status line repeats it. The value box keeps what you typed. The dialog opens on the joint
|
||||
|
||||
Reference in new issue
Block a user